Dr. SaMeH S. Ahmed

Associate Prof. of Environmental Engineering

Deposition (geolog

Deposition (geology)

Deposition is the geological process by which material is added to a landform or land mass. Fluids such as wind and water, as well as sedimentflowing via gravitytransport previously eroded sediment, which, at the loss of enough kinetic energy in the fluid, is deposited, building up layers of sediment.

Deposition occurs when the forces responsible for sediment transportation are no longer sufficient to overcome the forces of particle weight and friction, creating a resistance to motion, this is known as the null-point hypothesis. Deposition can also refer to the buildup of sediment from organically derived matter or chemical processes. For example, chalk is made up partly of the microscopic calcium carbonate skeletons of marine plankton, the deposition of which has induced chemical processes (diagenesis) to deposit further calcium carbonate. Similarly, the formation of coal begins with deposition of organic material, mainly from plants, in anaerobic conditions.

Null-point hypothesis

The null-point hypothesis explains how sediment is deposited throughout a shore profile according to its grain size. This is due to the influence of hydraulic energy, resulting in a seaward-fining of sediment particle size, or where fluid forcing equals gravity for each grain size.[2] The concept can also be explained as "sediment of a particular size may move across the profile to a position where it is in equilibrium with the wave and flows acting on that sediment grain." [3] This sorting mechanism combines the influence of the down-slope gravitational force of the profile and forces due to flow asymmetry, the position where there is zero net transport is known as the null point and was first proposed by Cornaglia in 1889.[3] Figure 1 illustrates this relationship between sediment grain size and the depth of the marine environment.

Figure 1. Illustrates the sediment size distribution over a shoreline profile, where finer sediments are transported away from high energy environments and settle out of suspension, or deposit in calmer environments. Coarse sediments are maintained in the upper shoreline profile and are sorted by the wave-generated hydraulic regime

The first principle underlying the null point theory is due to the gravitational force; finer sediments remain in the water column for longer durations allowing transportation outside the surf zone to deposit under calmer conditions. The gravitational effect, or settling velocity determines the location of deposition for finer sediments, whereas a grain's internal angle of friction determines the deposition of larger grains on a shore profile.[3] The secondary principle to the creation of seaward sediment fining is known as the hypothesis of asymmetrical thresholds under waves; this describes the interaction between the oscillatory flow of waves and tides flowing over the wave ripple bedforms in an asymmetric pattern. [4] "The relatively strong onshore stroke of the wave forms an eddy or vortex on the lee side of the ripple, provided the onshore flow persists, this eddy remains trapped in the lee of the ripple. When the flow reverses, the eddy is thrown upwards off the bottom and a small cloud of suspended sediment generated by the eddy is ejected into the water column above the ripple, the sediment cloud is then moved seaward by the offshore stroke of the wave." [4] Where there is symmetry in ripple shape the vortex is neutralised, the eddy and its associated sediment cloud develops on both sides of the ripple. [4] This creates a cloudy water column which travels under tidal influence as the wave orbital motion is in equilibrium.

The Null-point hypothesis has been quantitatively proven in Akaroa Harbour, New Zealand, The Wash, U.K., Bohai Bay and West Huang Sera, Mainland China, and in numerous other studies; Ippen and Eagleson (1955), Eagleson and Dean (1959, 1961) and Miller and Zeigler (1958, 1964).

Deposition of non-cohesive sediments

Large grain sediments transported by either bed load or suspended load will come to rest when there is insufficient bed shear stress and fluid turbulence to keep the sediment moving, [4] with the suspended load this can be some distance as the particles need to fall through the water column. This is determined by the grains downward acting weight force being matched by a combined buoyancy and fluid drag force [4] and can be expressed by:

 frac{4}{3} pi R^3 
ho_s g = frac{4}{3}  pi R^3 
ho g  + frac{1}{2} C_d 
ho pi R^2 w_s^2,

Downward acting weight force = Upward-acting buoyancy force + Upward-acting fluid drag force [4]


  • π is the ratio of a circle's circumference to its diameter.
  • R is the radius of the spherical object (in m),
  • ρ is the mass density of the fluid (kg/m3),
  • g is the gravitational acceleration (m/s2),
  • Cd is the drag coefficient, and
  • ws is the particle's settling velocity (in m/s).

In order to calculate the drag coefficient, the grain's Reynolds number needs to be discovered, which is based on the type of fluid through which the sediment particle is flowing; laminar flow, turbulent flow or a hybrid of both. When the fluid becomes more viscous due to smaller grain sizes or larger settling velocities, prediction is less straight forward and it is applicable to incorporateStokes Law(also known as the frictional force, or drag force) of settling. [4]

Deposition of cohesive sediments

Cohesion of sediment occurs with the small grain sizes associated with silts and clays, or particles smaller than 4ϕ on the phi scale. [4] If these fine particles remain dispersed in the water column, Stokes law applies to the settling velocity of the individual grains,[4] although due to sea water being a strong electrolyte bonding agent, flocculation occurs where individual particles create an electrical bond adhering each other together to form flocs.[4] "The face of a clay platelet has a slight negative charge where the edge has a slight positive charge, when two platelets come into close proximity with each other the face of one particle and the edge of the other are electrostatically attracted."[4] Flocs then have a higher combined mass which leads to quicker deposition through a higher fall velocity, and deposition in a more shoreward direction than they would have as the individual fine grains of clay or silt.

The occurrence of null point theory

Akaroa Harbour is located on Banks Peninsula, Canterbury, New Zealand, S43°N172°. The formation of this harbour has occurred due to active erosional processes on an extinct shield volcano, whereby the sea has flooded the caldera creating an inlet 16 km in length, with an average width of 2 km and a depth of -13 m relative to mean sea level at the 9 km point down the transect of the central axis. [5] The predominant storm wave energy has unlimited fetch for the outer harbour from a southerly direction, with a calmer environment within the inner harbour, though localised harbour breezes create surface currents and chop influencing the marine sedimentation processess. [6] Deposits of loess from subsequent glacial periods have in filled volcanic fissures over millenia,[7] resulting in volcanic basalt and loess as the main sediment types available for deposition in Akaroa Harbour

Figure 2. Map of Akaroa Harbour showing a fining of sediments with increased bathymetry toward the central axis of the harbour. Taken from Hart et al. (2009) and the University of Canterbury under contract of Environment Canterbury.[5]

Hart et al. (2009)[5] discovered through bathymetric survey, sieve and pipette analysis of subtidal sediments, that sediment textures were related to three main factors: depth; distance from shoreline; and distance along the central axis of the harbour. Resulting in the fining of sediment textures with increasing depth and towards the central axis of the harbour, or if classified into grain class sizes, “the plotted transect for the central axis goes from silty sands in the intertidal zone, to sandy silts in the inner nearshore, to silts in the outer reaches of the bays to mud at depths of 6 m or more”.[5] See figure 2 for detail.

Other studies have shown this process of the winnowing of sediment grain size from the effect of hydrodynamic forcing; Wang, Collins and Zhu (1988)[8]qualitatively correlated increasing intensity of fluid forcing with increasing grain size. "This correlation was demonstrated at the low energy clayey tidal flats of Bohai Bay (China), the moderate environment of the Jiangsu coast (China) where the bottom material is silty, and the sandy flats of the high energy coast of The Wash (U.K.)." This research shows conclusive evidence for the null point theory existing on tidal flats with differing hydrodynamic energy levels and also on flats that are both erosional and accretional.

Kirby R. (2002)[9] takes this concept further explaining that the fines are suspended and reworked aerially offshore leaving behind lag deposits of mainly bivalve and gastropod shells separated out from the finer substrate beneath, waves and currents then heap these deposits to form chenier ridges throughout the tidal zone which tend to be forced up the foreshore profile but also along the foreshore. Cheniers can be found at any level on the foreshore and predominantly characterise an erosion-dominated regime [9].

The best book

Prayer Times

Click here

Office hours

Sunday:     12-1

Monday:     12-1

Tuesday:     10-12

Wednesday: 10-11

You are welcome to contact me by at any time

You  may also contact me via WhatsApp group, ..

Ext. 2524

Civil Eng. Students

DON'T miss!

Love your department and be proud of your field of study

As we approaching the second midterm exams..  Get ready and remember our offices are open to answer you . do not hesitate to .contact me if you have difficulties

For CE 370 students : I do apologize for did not attend the extra lab session that proposed to be on Wednesday at 6 am.  Sorry

Good Luck


My Dear Students

Please visit the  announcement box for the relevant course and make sure that you can download and upload easily, otherwise

.contact me  to sort it out

There will be an orientation session in the midell of this term to help you select your track in Civil and Environmental Engineering


Special Issue

Electrical Power Resources: Coal versus Renewable Energy

  Published Online on January 2016

Mining Engineering

Mining engineering is an engineering discipline that involves practice, theory, science, technology, and the application of extracting and processing minerals from a naturally occurring environment. Mining engineering also includes processing minerals for additional value.

Environmental Engineering

Environmental engineers are the technical professionals who identify and design solutions for    environmental problems. Environmental engineers provide safe drinking water, treat and properly dispose of wastes, maintain air quality, control water pollution, and remediate sites contaminated due to spills or improper disposal of hazardous substances. They monitor the quality of the air, water, and land. And, they develop new and improved means to protect the environment.


Actions speak louder than words



College of Eng. MU



Universities I've worked in

Assuit University (Home University), Egypt

Imperial College, London, UK

Faculty of Engineering, Al-Mergeb University, Libya

King Saud University, KSA

,Majmaah University

Majmaah University has a very nice web page that provide  all information regarding deanships, colleges, activities,  campuses and many others. Search your request in

Also visit

My Academic Pages


and give me


How many red balls we need to make balance 


Egypt vs Tunisia (Handball final)  30/1/2016

Currency Converter

Click here


Click here

Course 2016/17-1

  1. Computer Applications in Surveying  CE 473
  2. Surveying 1 CE 370
  3. Photogrammetry CE 474
  4. Surveying II  CE 371
  5. Design I  (round 4) CE 498

The Rules of Life

Rule #7


Member of the Editorial Board: " Journal of Water Resources and Ocean Sciences"  2013


Participating in The Third International Conference on Water, Energy and Environment,(ICWEE) 2015 - American University of Sharjah, UAE 24-26 March 2015 with a Paper and Poster

New article

Recovery of Titania from Waste-Sludge of Majmaah Water Treatment Plant

"Production of Titania Nano-particles from Wast-


Coming soon

Results of M2 CE311

Student Conference

Participation  in the 6Th Student Conference

With a paper and oral presentation

From the Senior Design Project CE499 -35

See inside, the paper, and presentation

CE 370 Course

Surveying  I -  CE 370 - 2016-2017-1

Power point


Lecture notes

Second Midterm Exam


Model Answer
Inside, please follow:

Student Performance Records

CE 371 Course

Surveying II - CE 371 - 2016-2017-1


First midterm exam



See Inside

Student Performance Records

CE473 Course

Computer Applications in Surveying

CE 473


Power point


Exams + Quizzes


CE 474 Course

2015-2016-2 - Photogrammetry  CE474

Available 0-1-2-3-4 Power point


Quizzes 2 and 3 with model Answer

Available Chapter 1,2,3,4,5 Lecture notes

Report 1  Cameras Report


60 marks Exams

See Inside

Student Performance Records

CE 360 Course

Environmental Engineering 1

CE 360: Environmental Engineering 1


Y PP0-1-2-3,4 Power point
Y 1,2,3,4,5 Chapters

Water quality Poster + Climate Change Reports
will be announced (Quiz #2 will be using D2L- Online Quizzes


Quizzez 2,3 and 4 with model answer and results Exams and results

GE 306 Course

Engineering Report Writing

GE 306: Engineering Report Writing

CE 499 Course

Senior Design 2 - CE 499

Meeting on 14-4-2015

Second Best paper from Senior Design Projects in 2015

Paper title:

Evaluation of Groundwater Quality Parameters using Multivariate Statistics- a case Study of Majmaah, KSA


Abdullah A. Alzeer

Husam K. Almubark

Maijd M. Almotairi

CE 360-Summer Course

Environmental Engineering I

Welcome to CE360 second Term 2015-2016 

Engineering Practice

 Engineering Practice GE 307

What is your opinion

Contact me

Mobile: 00966598311652


Civil and Environmental Engineering Department
College of Engineering, Majmaah University
Majmaah, P.O. 66, 11952, KSA

Thank you

Your frequent visit to my website has helped  a lot to get the 2nd place in the university competition in the  year 1434-2013... Thanks very mush and please keep following my work

زيارتكم المتكررة لموقعي ساهمت في حصولي على المركز الثاني لاحسن المواقع الشخصية بجامعة المجمعة ...لكم جميعا خالص شكري وتقديري

CE 212 - Summer Course

Properties and Strength of Materials 1

CE 212

Y from PP0 to PP 6 + PDF Power points
Y Midterm #2 + Model Answer + results Exams
Y lab 3 Labs

Solution of Quiz 4 + Results HW

CE 311- Summer Course

Soil Mechanics and Foundation Engineering

CE 311

M2+ model Answer + PP 1-9 = PDF 1-9 all are available

Sheets 2 + 4 with model Answers

Results of M2

إحصائية الموقع

عدد الصفحات: 1412

البحوث والمحاضرات: 1541

الزيارات: 51070